Set up the phone and card
Use a flat, clean surface that contrasts with the card edge. Choose soft, even light. Hold the main camera above the middle of the card and keep the phone parallel to the table. Move back a little if the card is too close for the camera to focus. Keep enough detail to see both the physical edge and the inner printed frame.
Review the photo before measuring. If one end looks noticeably wider or the opposite edges converge, retake it. If a curved or heavily stylised frame makes the measurement ambiguous, use the guide to choosing repeatable border landmarks.
Place the lines at the same point on both borders
Open the photo centering calculator. Place the outer lines at the physical card edges and the inner lines where the border meets the printed frame. Compare the same height on the left and right and the same horizontal position on the top and bottom. Keep all four landmarks visible when you crop the photo.
Repeat the process for the back with its own photo. Check the PSA front and back example if you are comparing a result with a grade guideline.
What to do when two photos disagree
Suppose your first photo gives 56/44 and the retake gives 53/47 on the same axis. That difference is worth checking before you treat either number as exact. Inspect the outer edges for tilt, check where you placed the inner lines, and look for reflection from the sleeve or foil.
If the physical reference is visible, measure opposite borders in the same unit and use the calculator’s manual mode. Record the result with its side and axis. If measurements still disagree near a grader’s guideline, keep that uncertainty in your submission decision.
